Firmware
Language DM/PL, HP-GL (758x emulation), HP-GL/2
Supported character sets Standard ASCII
Supported fonts Sans serif (single stroke and medium)
ROM-based plots Condence plot, DIN plot
Environment
These specications are for the cutter without substrate.
Operating temperature 15 to 35°C (59 to 95°F)
Storage temperature −30 to 70°C (−22 to 158°F)
Relative humidity 35 to 75%, non-condensing
TIP: The use of dimensionally stable substrate is an essential pre-requisite to obtain high cut quality.
Additionally, substrate expansion or contraction may occur as a result of temperature variations. To improve the
dimensional stability of substrate, let it stabilize to the current environmental conditions before use, for a
minimum period of 24 hours.
Electrical
The power entry module detects the line voltage and switches automatically between 100 V and 240 V.
Input voltage 100–120/200–240 V ±10%
Input frequency 50/60 Hz
Maximum load current 2 A
Power consumption 85 VA
Fuses T2.0A 250V
WARNING! For continued protection against risk of re, replace fuses only with the same type and rating of
fuse.
ENWW Firmware 53
To Next Page
Loading...
