HP 54 Basic Cutter - Accessories; Set the tool type

HP Latex Cutter Extended Kit
This kit contains the following items:
●
Sandblast blades and holder
Sandblast blades are used for some very specic applications such as gravestones. These blades need a
special blade holder.
●
Pouncing kit, pin, and strip
The pouncing pin can be used if you prefer to pierce the substrate instead of cutting it. It comes together
with a pouncing kit and a cutting strip.
●
Black pen and pen holders
The pen can be used if you want to use the contour cutter as a drawing device. It comes with two pen
holders.
Set the tool type
The cutter is supplied with a knife, and alternative tools are available as accessories. All tools have one
parameter in common: the pressure. Other parameters are specic to the tool. Tool parameters can be changed
by changing them for the current user, or by changing the user.
NOTICE: The cutter will perform as specied only if a genuine HP tool is installed. Do not replace the standard
knife with products from other manufacturers.
1. Turn on the cutter.
2.
Press .
3.
Press or until you reach Tool. Press .
4.
Press or to change the tool.
5.
Press to conrm. An asterisk appears by the name of the tool, indicating that it is now selected.
6.
Press twice to leave the menu.
50 Chapter 8 Accessories ENWW