HP 8904A - Output Two Signals at Once; Output Ports

4
Output Two Signals at Once
In this Chapter In this chapter, you will learn to operate the Dual Output Ports
provided by Configuration Option
02. If your HP 8904A is equipped
with Option
02, this demonstration will show you how to:
Output a Signal at each Output Port
Vary the Phase Relationship of the Signals at each
Output Port
Set Up Some Applications that use the Dual Output Ports
Modulate at One Output Port and Sum at the Other (only for
instruments that are also equipped with four channels,
Option
01)
set Up Your Equipment
Connect your HP 8904A to the oscilloscope as shown above.
Note
A dual-trace oscilloscope is required to complete the
demonstrations in this chapter.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com