C-10
HP-IS
Codes
Table C-4.
HP-IS
Codes That Can Be Used
with
Option
03
Instruments.
Form:
APH<Amplitude Value><Terminator>
Example:
“APH2.123VL”
Enter Hop Mode amplitude parameter. Valid terminators are VL, MV and UV.
Form:
AHRCON or OF>
Example:
“AHROF
Amplitude Hop On/Off Control.
Form:
DPE<ON or OF>
Example:
“DPEOF
Digital Port On/Off Control.
Form:
FRH
<
Frequency Value> <Terminator>
Example:
“FRH723.5HZ”
Enter Hop Mode frequency parameter. Valid terminators are HZ and
KZ.
Form:
FHR<ON or OF>
Example:
“FHROF
Frequency Hop On/Off Control.
Form:
HRAd or
2
Digit Address>ET
Example:
“H RA9ET”
Enter Hop Register address. Addresses
0-15
are valid, valid terminator is ET.
Form:
PHHcPhase Value><Terminator>
Example:
“PHH59.3DG”
Enter Hop Mode phase. Valid terminators are
DG
and
RD.
Form:
PHR<ON
or
OF>
Example:
“PHROF
Phase Hop On/Off Control.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
