HP ProLiant DL360 Generation 3 Server Setup and Installation Guide 1-1
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: b-ch1 Planning the Server Installation.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/11/02 11:15 AM
1
Planning the Server Installation
If planning to deploy and configure multiple servers in a single rack, consult the HP
ProLiant DL360 Generation 3 Server High-Density Deployment white paper at
www.compaq.com/products/servers
HP ProLiant DL360 Generation 3 Server Features
For a list of features, which are standard on the HP ProLiant DL360 Generation 3
server, refer to
www.compaq.com/products/servers/proliantdl360
A generation identifier (G3), located on the front of the server, indicates the model of
the server purchased. The generation identifier is required to accurately identify the
model for service and support.
Server Installation Overview
The following steps give an overview of the required procedures for installing the
server:
IMPORTANT: Before beginning the following procedures, refer to the Important Safety
Information guide that shipped with the server.
1. Select an appropriate site for the rack.
2. Unpack the server and rack-mounting hardware.
To Next Page
Loading...
