Installing Hardware Options
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide 2-19
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: c-ch2 Installing Hardware Options.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/16/02 1:34 PM
7. Install the Processor Power Module into socket 2 (1) and close the locking
latches (2).
Figure 2-15: Installing a Processor Power Module
NOTE: PPMs with the same part number may look different, but are functionally equivalent.
Installing a Hot-Plug Redundant Power Supply
NOTE: Only one PCI slot is supported when the server utilizes two hot-plug redundant power
supplies.
Use this section to install a hot-plug redundant power supply.
Hot-Plug Power Supply Setup
The server can be configured with a single hot-plug AC or DC power supply or two
hot-plug AC or two hot-plug DC power supplies. When two hot-plug power supplies
are installed, the server has power redundancy. Depending on the server
configuration, procedures for installing or replacing the power supplies vary per the
following:
To Next Page
Loading...
