Installing Hardware Options
2-18 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: c-ch2 Installing Hardware Options.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/16/02 1:34 PM
CAUTION: If replacing an existing processor/heatsink assembly, be sure to
discard the old heatsink. The heatsink is not reusable.
5. Install the heatsink with the adhesive side down (1).
CAUTION: Before closing the heatsink retaining clip, be sure that the processor
socket locking lever is closed. Do not force the lever closed; it should close
without resistance. Forcing the lever closed may result in damage to the
processor socket, requiring replacement of the system board.
6. Close the heatsink retaining clips (2).
Figure 2-14: Installing the heatsink
To Next Page
Loading...
