HP DL360 - ProLiant - G3 - Hot-Plug Redundant Power Supply;Pci Switch (SW1) Settings; Debug LED Switch (SW3) Settings

LEDs, Switches, and Jumpers
E-8 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: j-appe LEDs, Switches, and Jumpers.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/11/02 11:23 AM
Hot-Plug Redundant Power Supply/PCI Switch (SW1) Settings
The hot-plug redundant power supply/PCI switch (SW1) is a four-position switch
used for system maintenance. Refer to the labels attached to the inside of the server
access panel for the proper switch settings. The following table shows the shipping
configuration of SW1.
Table E-5: Hot-Plug Redundant Power Supply/PCI Install Switch (SW1) Settings
Position Function Default Description
S1 Reserved Off Reserved
S2 Reserved Off Reserved
S3 Reserved Off Reserved
S4 Identify PCI slot or Hot-Plug
Redundant Power Supply
support
Off Off = Normal (PCI slot 2 supported)
On = Hot-Plug Redundant power
supply installed
Debug LED Switch (SW3) Settings
The Debug LED switch (SW3) is a four-position switch used for system
maintenance. The positions on this switch are currently reserved and are not modified
by the user.