HP ProLiant DL360 Generation 3 Server Setup and Installation Guide G-1
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: l-appg System Battery.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/11/02 11:24 AM
G
Battery
The HP ProLiant DL360 Generation 3 server has one memory device that requires a
battery for retaining stored information.
When the server no longer automatically displays the correct date and time, the
battery that provides power to the real-time clock may need replacement. With
normal use, battery life is usually about 5 to 10 years. Replace used batteries with HP
540-milliampere-hour lithium, 3 V replacement batteries (P/N 179322-001).
Battery Replacement
WARNING: To reduce the risk of electric shock or equipment damage:
• Do not disable the power cord grounding plug. The grounding plug is an
important safety feature.
• Plug the power cord into a grounded (earthed) electrical outlet that is
easily accessible at all times.
• Disconnect power from the server or other product by unplugging the
power cord from either the electrical outlet or the server or other product.
To install a new battery:
1. Access internal server components. Refer to “Accessing Internal Server
Components” in Chapter 2, “Installing Hardware Options.”
2. Remove the Battery-Backed Write Cache enabler battery pack.
3. Locate the battery holder on the system board. Refer to Figure 2-4 and Table 2-1
in Chapter 2, “Installing Hardware Options.”
To Next Page
Loading...
