HP DL360 - ProLiant - G3 - Installing a Second Processor and Processor Power Module (PPM)

Installing Hardware Options
2-16 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: c-ch2 Installing Hardware Options.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/16/02 1:34 PM
Installing a Second Processor and Processor Power
Module (PPM)
To install a second processor and PPM:
1. Unlatch the heatsink retaining clips (1).
2. Unlatch the processor socket locking lever (2).
IMPORTANT: The processor assembly is designed to fit one way into the socket. Carefully
align the processor base with the processor socket until the processor fits securely in the
socket.
CAUTION: Processor 2 is oriented 180 degrees from processor 1. To prevent
damage to the hardware, properly align the processor before installing.
Figure 2-11: Opening the heatsink retaining clips and
processor socket locking lever