Installing Hardware Options
2-24 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: c-ch2 Installing Hardware Options.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/16/02 1:34 PM
2. Be sure that the free end of the green/yellow safety wire is connected to a
suitable earth ground.
Figure 2-20: Verifying Redundant DC Power
Supply/PDU wiring
3. If a hot-plug AC power supply has been installed, connect the power cord to the
power source.
4. Connect the power cord to the power supply.
5. Be sure that the power supply LED is illuminated green.
6. Be sure that the front panel external health LED is illuminated green.
7. If removed earlier, reattach the cable retractor to the fixed rack rail.
8. Open the cable straps in the cable tray, route the power cord through the cable
straps, and then close the cable straps.
To Next Page
Loading...
