Installing Hardware Options
2-26 HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: c-ch2 Installing Hardware Options.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/16/02 1:34 PM
3. Connect the battery module cable to the battery-backed write cache enabler
battery pack (1) and to the Smart Array 5i memory connector on the system
board (2).
4. Route the battery module cable through the battery-backed write cache cable clip
on the system board (3).
NOTE: If necessary, remove the PCI riser board assembly to access the cable clip. Refer
to “Removing an Expansion Board” in this chapter, for more information.
Figure 2-22: Routing and connecting the battery-backed
write cache enabler cable (PCI riser board 1 removed for
clarity)
5. Reinstall the PCI riser board assembly into slot 1.
6. Reverse the procedures in the “Accessing Internal Server Components” section
earlier in this chapter.
To Next Page
Loading...
