Removal and Replacement Procedures
5. Remove the screws securing the optical device ejector to the chassis.
Figure 2-13: Removing optical device ejector screws
6. Press the tab on the side of the optical device ejector (1) to release it from the chassis.
NOTE: Access to the tab on the side of the optical device ejector is restricted. To push in the tab
on the optical device ejector, use a small flat object such as a key, screwdriver, or pen.
7. Lower the optical device ejector and remove it from the chassis (2).
Figure 2-14: Removing the optical device ejector from the chassis
2-16 HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide
To Next Page
Loading...
