Removal and Replacement Procedures
To remove a processor:
1. Power down the server. Refer to “Powering Down the Server” earlier in this chapter.
2. Remove the server from the rack. Refer to “Removing the Server from the Rack” earlier
in this chapter.
3. Remove the access panel. Refer to “Server Access Panel” earlier in this chapter.
4. Unlatch processor heatsink retaining clips (1).
5. Remove the heatsink (2).
Figure 2-39: Removing a heatsink
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide 2-35
To Next Page
Loading...
