HP DL360 Maintenance And Service Guide

Removal and Replacement Procedures
To replace the processor:
1. Install the processor into the socket (1).
2. Close the processor locking lever (2).
Figure 2-41: Installing and locking a processor in the socket
CAUTION: Heatsinks have an integrated, plastic-covered thermal pad. Remove the plastic
cover from the new heatsink to expose the adhesive side of the thermal pad before placing
the heatsink on the processor.
3. Remove the protective covering from the heatsink.
Figure 2-42: Removing the heatsink protective covering
HP ProLiant DL360 Generation 3 Server Maintenance and Service Guide 2-37

HP DL360 Specifications

General

Processor Sockets	2
CPU	Intel Xeon Scalable
Memory	Up to 3TB DDR4
Form Factor	1U Rack
Power Supply	Redundant Power Supplies, various wattage options
Network Controller	Embedded 1Gb or 10Gb Ethernet
RAID Support	Smart Array RAID
Operating System Support	Windows Server, Linux, VMware
Storage	Up to 10 SFF SAS/SATA/NVMe drives or 4 LFF SAS/SATA drives