HP DW017B - StorageWorks Ultrium 448 Tape Drive - Cabling to the Spare SAS Port (some HP Proliant Servers)

IMPORTANT:
This installation uses the SAS cable supplied with the tape drive to connect to an internal port on the host
SAS controller. It does not modify your existing SAS configuration.
1. Connect the SAS cable supplied with the tape drive to the spare SAS port on the host SAS controller.
1. SAS cable supplied with tape drive 4. Host SAS controller
2. Connec
t SAS cable to spare SAS port
5. Connector for tape drive
3. Unused connector on SAS cable
Figure 8 Cabling to t he s pare SAS port (some HP ProLiant servers)
2. Connect the other end of the SAS cable to the tape drive and connect a spare power cord from the
server’s internal power supply to the power connector on the tape drive.
Ultrium half-height SAS Tape Drives
27