HP DW017B - StorageWorks Ultrium 448 Tape Drive - Securing the Blanking Plate; Connecting the Cables to the Tape Drive

Figure 20 Securing the blanking plate
IMPORTANT:
On some servers, even those with latch-mounted arrangements, it is necessary to use the
supplied screw to secure the blanking plate.
5. Connect the other end of the SAS cable (threaded through the blanking plate to the outside of the
server) to the connector on the rear of the tape drive.
6. Plug the p ower cord securely into the socket on the rear panel of the drive and plug the other end of
the power cord into the power o utlet. The power on/off switch is on the front panel.
1. SAS connector
3. Power on/off switch
2. Power connector
Figure21Connectingthecablestothetapedrive
7.
Nowgoto“Reboot the server” on page 46.
Ultrium half-height SAS Tape Drives
41