HP E24mv G4 - Audio Connector Repair

24

2） Lift the CN1032/CN1033 connector from the circuit board.
3） Place the new component on the circuit board. Be sure that it matches the footprint.
4） Solder the new component.
Audio connector CN610
Repair the Audio connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Lift the CN610 connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the footprint.
4) Solder the new component.