Main terminal. The #2 black WLAN module antenna cable connects to the WLAN module #1 Aux
terminal.
6. Release the display panel cable and the WLAN module antenna cables from the retention clips (3)
and (4) that are built into the computer.
7. Remove the five Phillips M2.5 × 4.9 screws that secure the display assembly to the computer.
8. Swing the display hinges (1) up and back as far as they will go.
9. Open the display assembly (2) as far as it will open.
56
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
