f. When replacing the display panel assembly retention tape (1), align the holes (2) in the tape with
the alignment pins (3) on the display back cover.
g. Release the webcam/microphone module cable and wireless antenna cables from the left
display hinge area (1).
h. Release the display panel cable (2) from the right display hinge area.
i. Remove the display panel assembly (3) from the display back cover.
The display panel assembly is available using the following spare part numbers:
● N91014-001: 35.6 cm (14.0 in), 2880 × 1800, brightview, OLED + LBL, UWVA, DCI-P3, 100% CG,
eDP 1.4 + PSR, 120 Hz VRR, touchscreen display panel with narrow bent bezel; typical
brightness: 400 nits
● N91013-001: 35.6 cm (14.0 in), LCD, WUXGA (1366 × 768), antiglare, WLED + LBL, UWVA,
45% CG, sRGB 100, eDP 1.4 + PSR2, LP touchscreen display panel with narrow bent bezel;
typical brightness: 400 nits
Display assembly
47
To Next Page
Loading...
