● N91012-001: 35.6 cm (14.0 in), LCD, WUXGA (1366 × 768), antiglare, LED, UWVA, 45% CG,
eDP 1.2 without PSR, touchscreen display panel with narrow bent bezel; typical brightness:
300 nits
12. To remove the webcam/microphone module and cable:
a. Remove the display panel assembly.
b. Insert a tool (1) at the two locations shown in the following illustration.
NOTE: Be sure to insert the tool at the locations shown in the following illustration. These
locations are reinforced with metal to prevent damage during removal.
c. Carefully lift the webcam/microphone module to release it from the display back cover.
The webcam/microphone module is attached to the display back cover with double-sided
adhesive.
d. Turn the webcam/microphone module (2) over.
e. Ensure that the ZIF connector (3) the webcam/microphone module cable is connected to does
not release.
f. Detach the webcam/microphone module cable (1) from the display panel assembly. The
webcam/microphone module cable is attached to the display panel assembly with double-
sided adhesive.
48
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
