Figure 13: An example of network connections for two dedicated networks
71 Data port eth3a on controller BHost/server
2 8Ethernet switch 1 Management port eth0a on controller B
93 Data port connectionsEthernet switch 2
4 10Array Management port connections
115 Management interface pairData port eth3a on controller A
6 12Management port eth0a on controller A Data interface pair
Advanced Configuration
In this configuration:
• Management and data paths are on different subnets or networks
• eth0 ports handle management traffic
• eth1 through eth6 ports handle data traffic
The following example shows one possible way to connect the cabling for an advanced configuration. The data and management
paths are shown separately. Note that the subnet addresses in the data path illustration are just examples. Your settings will
differ. The advanced configuration uses the maximum number of data connections on the iSCSI network to obtain the best
availability and throughput.
In more advanced configurations, you can define your own network configuration to handle the desired I/O flow.
Install the HPE Storage Array 28
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
To Next Page
Loading...
