Note: The HPE Alletra 6030, 6050, 6070, and 6090 model array have six fans (shown). The HPE Alletra
6010 model array has only four fans. Fans are numbered sequentially, right to left in this illustration.
21 Fan 6Fan 1
c) Gently push the new fan into the empty slot until you hear the release latch click into place.
The fan only fits into the slot facing one way.
4. Return the controller to the chassis bay.
a) Make sure the controller release lever is fully extended.
b) Slide the controller into the chassis bay. Do not force the controller. If it does not slide in easily, remove it and try again.
c) After the controller is in place, return the controller release lever to its original closed position, and then tighten the
thumbscrews.
d) Reconnect all the network cables to the controller (as labeled from step 2).
e) Reconnect the power cables to both power supplies.
f) Verify that the controller is powered on.
After installation, the controller powers on automatically. The controller LEDs on the array remain on. If the controller
does not power on automatically, contact HPE Support.
g) Return the failed fan as directed on the RMA work order.
Replace the USB Boot Device
Use this procedure to replace the USB boot device in your HPE storage array.
Before you begin
With HPE Support direction, you can replace the USB boot device with the operating system boot image in a controller.
10-20 minutesTime required:
USB boot device ordered from HPEParts required:
Maintenance Procedures 87
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
To Next Page
Loading...
