31 Riser cardGuide post
2 4Groove Connector
d) With the riser cards and connectors properly aligned, press down on the top of the PCIe cage to seat the riser cards
in their connectors.
e) Press down on the fastener and turn the fastener tab one half turn (180°) clockwise to secure the PCIe cage.
7. Move the OCP card, if present, from the failed controller to the replacement controller.
a) Remove the OCP card from the failed controller.
Maintenance Procedures 74
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
To Next Page
Loading...
