d) Pull the controller release levers down until they stop. The controller ejects slightly from the chassis.
e) Supporting the weight of the controller, pull the controller release levers to slide the controller out of the chassis. Then
place the controller on a flat surface.
31 ChassisController release lever (open)
2 Controller
Important:
To avoid electrostatic damage, place array components on a grounded anti-static mat. Use an ESD wrist strap
during removal and replacement.
3. Replace the USB boot device.
a) Locate the USB boot device on the controller board.
Maintenance Procedures 89
Documentation Feedback: doc-feedback-hpe-storage@hpe.com
To Next Page
Loading...
