Removing the server from the pedestal kit
Required tools
No tools are required for disassembling the pedestal kit.
Power off the server and remove cables
1. Power down the server using the instructions provided in the server service guide.
2. Disconnect the power and LAN cables connected to the server.
Removing the pedestal kit
1. Remove pedestal feet.
Figure 32 Removing the pedestal kit feet
2. Remove the pedestal side pieces by unscrewing the captive thumbscrews on the rear of the
pedestal kit, and sliding the side pedestal kit pieces toward the back of the server.
HP Confidential100 Removal and replacement procedures
To Next Page
Loading...
Need help?
General