Verifying installed components in the server
Use the following procedure to verify that the components you have installed into the server are
recognized by the server:
1. Press S to enter the UEFI shell.
2. Wait for the UEFI Shell prompt to appear.
3. Enter info all from the UEFI Shell prompt. The following appears:
NOTE: Your display might not match the display shown.
info all
SYSTEM INFORMATION
[Details omitted]
CPU INFORMATION
[Details omitted]
BOOT PROCESSOR INFORMATION
[Details omitted]
MEMORY INFORMATION
[Details omitted]
I/O INFORMATION
[Details omitted]
PCI DEVICE INFORMATION
[Details omitted]
CONSOLE CONFIGURATION
[Details omitted]
BOOT INFORMATION
[Details omitted]
FIRMWARE INFORMATION
[Details omitted]
SYSTEM SECURITY CONFIGURATION
[Details omitted]
Shell>
HP Confidential Verifying installed components in the server 57
To Next Page
Loading...
Need help?
General