Chapter 4
Utilities
EFI/POSSE Commands
42
Operation
If a user enters no parameters, the usage is displayed. Otherwise, the specified error log is displayed. Adding
-n to the clear parameter disables the confirmation prompt. (The errdump command can also be accessed via
the System Configuration menu.)
info
Allows the user to display most system information.
Syntax
info [ -b] [target]
Parameters
target: valid targets are:
all display everything
cpu display information on cpus
cache display information on cache
mem display information on memory
io display information on io
boot display boot-related information
chiprev display information on chip revisions
fw display firmware version information
sys display system information
warning display warning and stop boot information
Example 4-9 info -b all Command
Shell> info -b all
PROCESSOR INFORMATION
# of L3 L4 Family/
CPU Logical Cache Cache Model Processor
Slot CPUs Speed Size Size (hex.) Rev State
---- ------- -------- ------ ------ ------- ---- ------- -
0 1 1 GHz 3 MB None 1F/01 B2 Active
1 1 1 GHz 3 MB None 1F/01 B2 Active
2 1 1 GHz 3 MB None 1F/01 B2 Sched Deconf
3 1 1 GHz 3 MB None 1F/01 B2 Active
MEMORY INFORMATION
Extender 0:
--- DIMM A ----- ---- DIMM B ----- ----DIMM C ----- ---- DIMM D -----
DIMM Current DIMM Current DIMM Current DIMM Current
--- ------ ---------- ------ ----------- ------ ---------- ----- -------------
0 256 MB Active 256 MB Active 256 MB Active 256 MB Active
1 ---- ---- ---- ----
2 ---- ---- ---- ----
3 ---- ---- ---- ----
4 ---- ---- ---- ----
5 ---- ---- ---- ----
Extender 1:
--- DIMM A ----- ---- DIMM B ----- ----DIMM C ----- ---- DIMM D -----
DIMM Current DIMM Current DIMM Current DIMM Current
--- ------ ---------- ------ ----------- ------ ---------- ----- -------------
0 256 MB Active 256 MB Active 256 MB Active 256 MB Active
1 ---- ---- ---- ----
2 ---- ---- ---- ----
3 ---- ---- ---- ----
To Next Page
Loading...
Need help?
General