Job Storage
When Job Storage is enabled, the product can store print jobs so that you can gain access to those
print jobs later at the control panel.
Secure Printing
The new HP UPD option Encrypt Job (with password) is available for use with this printer and
provides end-to-end secure print job transmission with mutual authentication on the supported devices.
The print job is sent and stored encrypted, and can only be printed after entering the password on the
device.
Setting this to disabled results in the setting Encrypt Job not to be listed under Make Job Private/
Secure on the Job Storage tab.
The default is Automatic, enabling the setting to be selected from the Job Storage tab.
Job Separator
Use this control to specify whether a print job identifier page should be printed between print jobs. The
Job Separator feature is disabled by default.
Mopier Mode
The multiple-original print (mopy) function is an HP-designed feature that produces multiple, collated
copies from a single print job. Multiple-original printing (mopying) increases performance and reduces
network traffic by transmitting the job to the product once, and then storing it in memory or on the hard
disk. The remainder of the copies are printed at the fastest speed. All documents that are printed in
mopier mode can be created, controlled, managed, and finished from the computer, which eliminates
the extra step of using a photocopier.
The HP LaserJet Enterprise 500 color M551 supports the transmit-once mopying feature when the
Mopier Mode: setting on the Device Settings tab is Enabled.
When you use the HP PCL 6 Print Driver, mopying is performed in one of two ways: either through the
software or through the product hardware. When mopier mode is enabled, mopying takes place
through the product hardware. One copy of a multiple-page print job is transmitted once through the
network to the product, together with a printer job language (PJL) command directing the product to
make the specified number of copies.
When you disable mopier mode, you are not necessarily disabling multiple collated copies, which the
driver can still perform through the software rather than the product hardware (the mopying path that is
disabled when you change the Mopier Mode setting to Disabled). However, a multiple-copy print
job that is sent when the mopier is disabled loses the advantage of transmitting the print job once,
because the job is sent through the network for each collated copy.
Mopier mode and collation
Mopying and collating print jobs are independent but closely related functions. Mopying, the ability to
send original print jobs to the product, is performed by the print driver. Collating can be controlled by
either the print driver or the document software program. The mopying mode is selected by default in
ENWW
Device Settings tab features
113
To Next Page
Loading...
