HP LASERJET ENTERPRISE 500 - Custom Paper Size; Figure 3-7 Custom Paper Size Dialog Box; Name

Because paper-size settings in most software programs override driver settings, it is generally best to
use the driver to set paper size only when you are printing from software programs that do not include
a paper-size setting, such as NotePad, or when you are producing a book or a booklet that does not
require different paper sizes.
NOTE: Certain software programs can override the size command and specify different paper sizes
within a single document.
When you change the print-driver setting to a paper size that is not currently loaded in the product, a
control-panel message appears that prompts you to load the paper size or select another tray.
For information about paper sizes, see Paper attributes and commands on page 152 .
When the Settings under the Special pages section have been changed, the Paper sizes, Paper
source, and Paper type menus change also, offering a variety of options. For more information, see
Special pages on page 71.
Custom Paper Size
The Custom Paper Size dialog box appears when you click Custom… on the Paper/Quality
tab. The following figure shows the initial appearance of the Custom Paper Size dialog box.
Figure 3-7 Custom Paper Size dialog box
NOTE: The HP LaserJet Enterprise 500 color M551 product supports custom paper sizes up to 14
inches in length and 8.5 inches in width. The driver will be updated to enable printing to the maximum
size.
Name
Use the Name text box to type a new name for a custom paper size. When you change the name to
something other than Custom, the Save and OK buttons become active.
64 Chapter 3 HP PCL 6 print driver for Windows ENWW