the driver, and can be disabled by changing the Mopier Mode setting on the Device Settings tab
to Disabled.
Control collation through the print driver by selecting or clearing the Collated check box on the
Advanced tab. Click Copy Count under the Paper Output setting. You can clear the check box,
which is available only when the Copy Count option is set to more than 1 copy, to allow the software
program to control collation.
To receive uncollated multiple copies of a print job, you must clear the Collated check box and make
sure that the software program collation feature is not selected.
The following table shows the relation between mopier mode settings and collation settings in the
software program and the driver. The first three columns show the settings; the last column, "Expected
result", shows how a 3-page print job would appear.
Table 3-5 Driver mopier mode and collation settings
Mopier mode Application collation Driver collation Expected result
Disabled Not selected Not selected 3 copies uncollated
Disabled Not selected Selected 3 copies uncollated
Disabled Selected Not selected 3 copies collated
Disabled Selected Selected 3 copies collated
Enabled Not selected Not selected 3 copies uncollated
Enabled Not selected Selected 3 copies uncollated
Enabled Selected Not selected 3 copies collated
Enabled Selected Selected 3 copies collated
114 Chapter 3 HP PCL 6 print driver for Windows ENWW
To Next Page
Loading...
