Removal and replacement procedures
Rollers
Multipurpose (MP) tray pickup roller
1. Open the toner cartridge door, and then remove the toner cartridge.
2. Pull back and hold the pickup roller cover (callout 1), press the tabs (callout 2) on both ends of the
pickup roller away from the roller — which should cause the roller to move up — and then remove
the roller.
Figure 1-3 Remove the MP tray roller
2
1
Multipurpose (MP) tray separation pad
To remove the separation pad, you must first remove the pickup roller assembly.
1. Remove the following components:
●
Tray 2 cassette
●
Left cover. See
Left cover on page 13.
2. Open the toner cartridge door, and then remove the toner cartridge.
6 Chapter 1 Removal and replacement ENWW
For more information and parts on the HP LaserJet Pro 400, M425 call 800-551-1943 or order on line at www.printersupplies.com
To Next Page
Loading...