HP laserjet pro 400 mfp - Multipurpose (MP) tray pickup gear assembly

2. In the toner cartridge cavity, pull the sheet-metal jam plate toward the Tray 1 pickup roller cover
(callout 1) and hold it, release the two tabs of the black locking clip on the right-side bushing
(callout 2), pull the bushing up, and then slide the transfer roller (callout 3) to the right and remove
it.
Figure 1-75 Remove the transfer roller
3
2
1
CAUTION: The black locking clip on the right side of the transfer-roller shaft is not captive. Do
not lose the locking clip when you remove the transfer roller.
Multipurpose (MP) tray pickup gear assembly
NOTE: The multipurpose tray is referred to as Tray 1 in user documentation.
1. Remove the following components.
●
Tray 2 cassette
●
Left cover. See
Left cover on page 13.
ENWW
Removal and replacement procedures
53
For more information and parts on the HP LaserJet Pro 400, M425 call 800-551-1943 or order on line at www.printersupplies.com