HP MSR1003-8S

255
snmp mib event trigger
Use snmp mib event trigger to create a trigger and enter trigger view. If the trigger exists, this command
enters trigger view directly.
Use undo snmp mib event trigger to remove a trigger.
Syntax
snmp mib event trigger owner trigger-owner name trigger-name
undo snmp mib event trigger owner trigger-owner name trigger-name
Default
No trigger exists.
Views
System view
Predefined user roles
network-admin
Parameters
event-owner: Specifies an owner for a trigger. Specify an existing SNMPv3 user for the argument.
event-name: Specifies a name for a trigger, a case-sensitive string of 1 to 32 characters.
Usage guidelines
A trigger is identified by its owner and name.
For more information about SNMPv3 user access rights, see Network Management and Monitoring
Configuration Guide.
Examples
# Create a trigger with the owner owner1 and name triggerA.
<Sysname> system-view
[Sysname] snmp mib event trigger owner owner1 name triggerA
[Sysname-trigger-owner1-triggerA]
snmp-agent trap enable event-mib
Use snmp-agent trap enable event-mib to enable the Event MIB trap feature.
Use undo snmp-agent trap enable event-mib to disable the Event MIB trap feature.
Syntax
snmp-agent trap enable event-mib
undo snmp-agent trap enable event-mib
Default
The Event MIB trap feature is enabled.
Views
System view