42
Parameters
active: Sets the data transmission mode to active. The FTP server initiates a connection request.
passive: Sets the data transmission mode to passive. The FTP client initiates a connection request.
Examples
# Set the data transmission mode to passive for the FTP operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type ftp
[Sysname-nqa-admin-test-ftp] mode passive
next-hop
Use next-hop to specify the next hop for the ICMP echo operation.
Use undo next-hop to remove the next hop IP address.
Syntax
next-hop ip-address
undo next-hop
Default
No next hop IP address is configured for the ICMP echo operation.
Views
ICMP echo operation view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the IP address of the next hop.
Examples
# Specify 10.1.1.1 as the next hop IP address for the ICMP echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] next-hop 10.1.1.1
next-hop ipv6
Use next-hop ipv6 to specify the next hop IPv6 address for the ICMP echo operation.
Use undo next-hop ipv6 to remove the next hop IPv6 address.
Syntax
next-hop ipv6 ipv6-address
undo next-hop ipv6
To Next Page
Loading...
Need help?
General
