HP MSR1003-8S

361
Flow mirroring commands
This feature is supported only on the following ports:
• Layer 2 Ethernet ports on Ethernet switching modules.
• Fixed Layer 2 Ethernet ports on MSR2004-24/2004-48 routers.
• Fixed Layer 2 Ethernet ports on MSR1002-4/1003-8S routers.
mirror-to
Use mirror-to to configure a mirroring action for a traffic behavior.
Use undo mirror-to to delete a mirroring action.
Syntax
mirror-to interface interface-type interface-number
undo mirror-to interface interface-type interface-number
Default
No mirroring action is configured for a traffic behavior.
Views
Traffic behavior view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
The device supports mirroring traffic to multiple interfaces. You can configure multiple actions of
mirroring traffic to these interfaces for a traffic behavior.
Examples
# Create traffic behavior 1 and configure the action of mirroring traffic to GigabitEthernet 2/0/1 for the
traffic behavior.
<Sysname> system-view
[Sysname] traffic behavior 1
[Sysname-behavior-1] mirror-to interface gigabitethernet 2/0/1