Table 7-2 Speakers descriptions and part numbers
Description Spare part number
Models with 5090, 5080, or 5070Ti graphics P30867-001
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Remove the battery (see Removing and reinstalling the same battery on page 41).
Remove the speakers:
1. Disconnect the speaker cable (1) from the system board.
2. Remove the speaker cable from the tape (2) and clips (3).
3. Remove the two Phillips M1.6 × 3.0 screws (4) that secure each speaker to the computer.
4. Remove the speakers from the computer (5) .
NOTE: When removing the speakers, make note of the location of the rubber isolators (6). The
absence of or damage to these isolators can result in degraded speaker performance.
To install the speakers, reverse this procedure.
USB board
To remove the USB board, use this procedure and illustration.
54
Chapter 7 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
