HP OMEN MAX - Touchpad

2. Remove the Phillips M2.0 × 4.0 screw (2) that secures the board to the computer, and then remove
the board (3).
To install the ULL board, reverse this procedure.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 7-11
Touchpad description and part number
Description Spare part number
Models with 5090, 5080, or 5070Ti graphics, ceramic white P30873-001
Models with 5090, 5080, or 5070Ti graphics, shadow black P30874-001
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 38).
2. Remove the bottom cover (see Bottom cover on page 38).
3. Remove the system board (see System board on page 58).
Remove the touchpad:
Touchpad
65