To Next Page

To Previous Page

4 Removal and replacement procedures

Adherence to these procedures and precautions is essential for proper service.

Preparation for disassembly

Use this information to properly prepare to disassemble and reassemble the monitor.

1) Read the “Important safety information” and “Important service information and precautions” sections in

the “Getting started” chapter of this guide.

2) Clean the room for disassembly.

3) Identify the disassembly area.

4) Check the position that the monitors are to be placed along with the number of monitors. Prepare the area

for material flow according to the disassembly layout.

5) Be sure to have the following equipment and materials:

• Press fixture

• Working table

• Screwdriver

• Knife

• Gloves

• Cleaning cloth

• ESD protection

• Scraper bar in the following dimensions:

Rear Cover

Before removing the Rear Cover, follow these steps:

▲ Prepare the monitor for disassembly. See Preparation for disassembly on page 14.

Remove the Rear Cover of P19b G4&V19:

1) Remove four screws from the rear case.

Questions and Answers:

Need help?

Do you have a question about the HP P19b G4 and is the answer not in the manual?

HP P19b G4 Specifications

General