To Next Page

To Previous Page

3. Attach the base to the stand.

Mounting the monitor head

To attach your monitor to a wall using a swing arm or other mounting xture, follow the steps in this section

to safely and securely connect your monitor.

IMPORTANT: This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a third-

party mounting solution to the monitor head, use four 4 mm, 0.7 pitch, and 10 mm long screws. Longer

screws might damage the monitor. Be sure that the manufacturer’s mounting solution is compliant with the

VESA standard and is rated to support the weight of the monitor head. For best performance, use the power

and video cables provided with the monitor.

NOTE: This apparatus is intended to be supported by a UL-listed or CSA-listed wall-mount bracket.

Removing the monitor stand

If you decide to use a wall mount instead of the monitor stand that you attached, rst remove the stand.

IMPORTANT: Before disassembling the monitor, be sure that the monitor is turned o and all cables are

disconnected.

1. Disconnect and remove all cables from the monitor.

2. Position the monitor facedown on a at surface covered by protective sheet made of foam or a clean, dry

cloth.

3. Press the button on the connector on the back of the monitor (1).

Mounting the monitor head 7

Questions and Answers:

Need help?

Do you have a question about the HP P24h and is the answer not in the manual?

HP P24h Specifications

General