To Next Page

To Previous Page

2–10 Maintenance and Service Guide

Troubleshooting

Restoring Default Settings in the Setup Utility

The following procedure explains how to restore the Setup Utility

default settings. If the Setup Utility is not already running, begin

at step 1. If the Setup Utility is already running, begin at step 2.

1. To start the Setup Utility, turn on or restart the computer, and

then press

f10 while “Press <F10> to enter setup” is displayed

in the lower-left corner of the screen.

2. Select Exit > Load Setup Defaults, and then press

enter.

3. When the Setup Confirmation is displayed, press

enter to save

your preferences.

4. To set your preferences and exit the Setup Utility, press

f10,

and then follow the instructions on the screen.

The Setup Utility default settings are set when you exit the

Setup Utility and go into effect when the computer restarts.

✎

Your password, security, and language settings are not changed

when you restore the factory default settings.

Using Advanced Setup Utility Features

This guide describes the Setup Utility features recommended for

all users. For more information about the Setup Utility features

recommended for advanced users only, refer to Help and Support,

which is accessible only when the computer is in Windows.

The Setup Utility features available for advanced users include a

hard drive self-test, a Network Service Boot, and settings for boot

order preferences.

The “<F12> to boot from LAN” message that is displayed in the

lower-left corner of the screen each time the computer is started

or restarted in Windows is the prompt for a Network Service

Boot.

Other manuals for HP Pavilion dv9000

Questions and Answers:

Need help?

Do you have a question about the HP Pavilion dv9000 and is the answer not in the manual?

General