EasyManuals Logo

HP ProCurve 5300xl Series User Manual

HP ProCurve 5300xl Series
664 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #387 background imageLoading...
Page #387 background image
Access Control Lists (ACLs) for the Series 5300xl Switches
Configuring and Assigning an ACL
Comparison Operators:
eq < tcp/udp-port-nbr >“Equal To”; to have a match with
the ACE entry, the TCP or UDP source port number in a
packet must be equal to < tcp/udp-port-nbr >.
gt < tcp/udp-port-nbr >“Greater Than”; to have a match
with the ACE entry, the TCP or UDP source port number
in a packet must be greater than < tcp/udp-port-nbr >.
lt < tcp/udp-port-nbr >“Less Than”; to have a match with
the ACE entry, the TCP or UDP source port number in a
packet must be less than < tcp/udp-port-nbr >.
neq < tcp/udp-port-nbr>“Not Equal”; to have a match
with the ACE entry, the TCP or UDP source port number
in a packet must not be equal to < tcp/udp-port-nbr >.
range < start-port-nbr > < end-port-nbr >To have a match
with the ACE entry, the TCP or UDP source port number
in a packet must be in the range < start-port-nbr > < end
-
port-nbr >.
Port Number or Well-Known Port Name:
Use the TCP or UDP port number required by your
application. The switch also accepts these well-known TCP
or UDP port names as an alternative to their corresponding
port numbers:
TCP: bgp, dns, ftp, http, imap4, ldap, nntp, pop2, pop3, smtp, ssl,
telnet
UDP: bootpc, dns, ntp, radius, radius-old, rip, snmp, snmp-trap,
tftp
To list the above names, press the
[Shift] [?] key combination
after entering an operator. For a comprehensive listing of
port numbers, visit www.iana.org/assignments/port
numbers.
< any | host < dest-ip-addr > | ip-addr/mask-length >
In an extended ACL, this parameter defines the destination
IP address (DA) that a packet must carry in order to have
a match with the ACE. The options are the same as shown
for < src-ip-addr >.
[< dest-port tcp/udp-id >]
In an extended ACL, this parameter defines the TCP or UDP
destination port number a packet must carry in order to
have a match with the extended ACE. The options are the
same as shown above on the preceding page for the source
IP address.
9-41

Table of Contents

Other manuals for HP ProCurve 5300xl Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 5300xl Series and is the answer not in the manual?

HP ProCurve 5300xl Series Specifications

General IconGeneral
BrandHP
ModelProCurve 5300xl Series
CategorySwitch
LanguageEnglish

Related product manuals