IP Routing Features
Configuring RIP
RIP Parameters and Defaults
The following tables list the RIP parameters, their default values, and where
to find configuration information.
RIP Global Parameters
11-3 lists the global RIP parameters and their default values.
Table 11-3. RIP Global Parameters
Parameter Description Default
RIP state Routing Information Protocol V2-only. Disabled
auto-summary Enable/Disable advertisement of summarized routes. Enabled
metric Default metric for imported routes. 1
redistribution RIP can redistribute static and connected routes. (RIP Disabled
redistributes connected routes by default, when RIP is
enabled.)
RIP Interface Parameters
11-4 lists the VLAN interface RIP parameters and their default values.
Note RIP interface configuration is performed on VLAN interfaces in the switches
covered by this manual.
Table 11-4. RIP Interface Parameters
Parameter Description Default
RIP version The version of the protocol that is supported on the
interface.
The version can be one of the following:
• Version 1 only
• Version 2 only
• Version 1 compatible with version 2
metric A numeric cost the routing switch adds to RIP routes
learned on the interface. This parameter applies only
to RIP routes.
V2-only
1
11-22
To Next Page
Loading...
