HP ProCurve 5406zl Access Security Guide

TACACS+ Authentication
Configuring TACACS+ on the Switch
For example, here is a set of access options and the corresponding commands
to configure them:
Console Login (Operator or Read-Only) Access: Primary using TACACS+ server.
Secondary using Local.
ProCurve (config)# aaa authentication console login tacacs local
Console Enable (Manager or Read/Write) Access: Primary using TACACS+ server.
Secondary using Local.
ProCurve (config)# aaa authentication console enable tacacs local
Telnet Login (Operator or Read-Only) Access: Primary using TACACS+ server.
Secondary using Local.
ProCurve (config)# aaa authentication Telnet login tacacs local
Telnet Enable (Manager or Read/Write Access: Primary using TACACS+ server.
Secondary using Local.
ProCurve (config)# aaa authentication telnet enable tacacs local
Deny Access and Close the Session After Failure of Two Consecutive Username/Password Pairs:
ProCurve (config)# aaa authentication num-attempts 2
5-14

HP ProCurve 5406zl Specifications

General

Product Name	HP ProCurve 5406zl
Category	Switch
Layer	Layer 3
Operating Temperature	32°F to 131°F (0°C to 55°C)
Operating Humidity	15% to 95% non-condensing
Management	SNMP, CLI
Power Supply	Redundant power supplies (optional)
Memory	128 MB flash, 512 MB SDRAM