Removal and replacement procedures 59
CAUTION: To allow heat sink to draw as much heat as possible from the processor base, there must
be good contact between the heat sink base and the top of the processor. To ensure good contact,
you must apply thermal grease compound.
To install the new processor:
1. Squeeze the push fingers of the processor installation tool.
2. Align the tool on the processor; release the push fingers and hold the processor.
Figure 38 Picking up the Processor with the Installation Tool
3. Insert the processor into the socket.
Figure 39 Aligning and Inserting the Processor
4. Squeeze the push fingers of the processor installation tool to release the processor.
5. Remove the processor installation tool.
6. Engage the retention plate.
To Next Page
Loading...
