HP ProLiant DL360 Generation 4

22 HP ProLiant DL360 Generation 4 Server Maintenance and Service Guide
− Remove the SATA hard drive.
IMPORTANT: When SATA hard drives are installed, SATA LED
functionality and SATA hot-plug capability are not supported currently.
To replace the drive, slide the drive into the bay until the latch mechanism
engages the server chassis, then close the latch handle to lock the drive in the
server chassis.
Diskette Drive Blank
1. Power down the server ("Powering Down the Server" on page 16).
2. Extend the server from the rack ("Extending the Server from the Rack" on
page 17
).
3. Remove one of the following from the left hard drive bay:
− Hard drive blank (on page 19
)
− Hard drive (on page 21
)
4. Use a Torx T-10 screwdriver to remove the locking screw.