HP ProLiant DL360 Generation 4

36 HP ProLiant DL360 Generation 4 Server Maintenance and Service Guide
a. Remove the riser board with the slot for full-length expansion boards.
b. Repeat the previous step for the riser board with the slot for half-length
expansion boards, if needed.
To replace the component, reverse the removal procedure.
Power Converter Module
1. Power down the server ("Powering Down the Server" on page 16).
2. Remove all hot-plug power supplies ("Hot-Plug AC Power Supply" on page
27
).
3. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 17
).
4. Remove the access panel ("Removing the Access Panel" on page 18
).