Removal and Replacement Procedures 23
5. Remove the diskette drive blank.
To replace the component, reverse the removal procedure.
Diskette Drive
1. Power down the server ("Powering Down the Server" on page 16).
2. Extend the server from the rack. ("Extending the Server from the Rack" on
page 17
)
3. Remove one of the following from the left hard drive bay:
− Hard drive blank (on page 19
)
− Hard drive (on page 21
)
4. Use a Torx T-10 screwdriver to remove the locking screw.
To Next Page
Loading...
