HP ProLiant DL360 Generation 4

30 HP ProLiant DL360 Generation 4 Server Maintenance and Service Guide
5. Remove the component from the server.
To replace the component, reverse the removal procedure.
Optical Device and Diskette Drive Interface
1. Power down the server ("Powering Down the Server" on page 16).
2. Remove all hard drives and hard drive blanks ("Hard Drive" on page 21
).
3. Eject the optical device ("Optical Device" on page 25
).
4. Extend or remove the server from the rack ("Extending the Server from the
Rack" on page 17
).
5. Remove the access panel ("Removing the Access Panel" on page 18
).
6. Remove the diskette drive ("Diskette Drive" on page 23
).
7. Disconnect the cable from the optical device and diskette drive interface
board.
8. Use a T-15 Torx screwdriver to remove the two screws securing the board to
the server chassis.