HP ProLiant DL360 Generation 4

40 HP ProLiant DL360 Generation 4 Server Maintenance and Service Guide
Memory Options
You can expand server memory by installing PC2700 DDR SDRAM DIMMs.
The system supports up to four ECC Registered DDR SDRAM DIMMs.
NOTE: The Advanced Memory Protection option in RBSU provides
additional memory protection beyond Advanced ECC. By default, the
server is set to Advanced ECC Support. Refer to "ROM-Based Setup
Utility ("HP ROM-Based Setup Utility" on page 56
)," on the
Documentation CD, for more information.
The server supports two types of memory configurations:
•
•
•
•
•
•
•
Standard memory configuration for maximum performance with up to 8 GB
of active memory (four 2-GB memory modules)
Online spare memory configuration for maximum availability with up to
4 GB of active memory while simultaneously supporting up to 4 GB of
online spare memory
DIMM Installation Guidelines
You must observe the following guidelines when installing additional memory:
DIMMs installed in the server must be Registered DDR DRAM, 2.5 volts, 64
bits wide, and ECC.
DIMMs in slots 1A and 2A must match.
DIMMs in slots 3B and 4B must match and must be installed as a pair.
All DIMMs installed must be the same speed. Do not install DIMM modules
supporting different speeds.
Install DIMMs into both slots within a single bank. DIMMs must be installed
in order. Upgrade memory by installing DIMM pairs into banks in sequential
bank order, starting with bank B.
DIMM
1. Power down the server ("Powering Down the Server" on page 16).